SETTINGS
SETTINGS > CONTROL POINT > GENERAL
ENVOY™ TRANSCEIVER REFERENCE MANUAL 207
Show Channel Frequency
The Show Channel Frequency entry sets whether or not frequencies are shown
on the channel screen.
To show:
• both the transmit and receive frequencies, select Yes
• no frequencies, select No
Default value: Yes
Frequency Format
The Frequency Format entry sets the format in which frequencies are shown on the
screen. These values change the number of decimal points that are shown.
If you want to show the frequency to:
• one decimal point, select Show 100 Hz
• two decimal points, select Show 10 Hz
• three decimal points, select Show 1 Hz
Default value: Show 100 Hz
CAUTION: If a frequency is entered to the nearest 1 Hz, but the frequency format
is set to show the frequency on the screen to the nearest 100 Hz,
rounding will occur.
NOTE: If you need to know the exact frequency of a channel, you can view this
in User Data > Channels, then select the specific channel.
Call Key Options
The Call Key Options entry sets the default action that occurs when the CALL key
is pressed on the control point. The screen that is not set as the default action is
accessed using hold CALL.
If you want a press of the CALL key to:
• go to the Call screen, select Show Call Screen
• go to the Contacts screen, select Show Contacts Screen
Default value: Show Call Screen
To Next Page
Loading...
Need help?
General
