Codan Envoy - Brightness; Custom Brightness; Auto DIM Time; Key Beeps

SETTINGS
SETTINGS > CONTROL POINT > GENERAL
ENVOY™ TRANSCEIVER REFERENCE MANUAL 209
Brightness
The Brightness entry sets the brightness of the LCD and keypad backlight.
To define a custom brightness level, select Custom, then enter the required
brightness in the Custom Brightness entry.
Available values: Low, Medium, High, Custom
Default value: High
Related links:
Custom Brightness on page 209
Custom Brightness
The Custom Brightness entry sets the brightness of the LCD and keypad backlight
if Custom is selected in the Brightness entry.
Range: 5 to 100
Default value: 50
Related links:
Brightness on page 209
Auto Dim Time
The Auto Dim Time entry sets the time the transceiver waits after a key is pressed
before switching off the backlighting on the LCD and keypad of the control point. The
backlighting is automatically switched on again when a key is pressed.
Available values: 5, 10, 20 min
Default value: 10 min
Key Beeps
The Key Beeps entry sets whether or not a beep is heard when a key is pressed.
When you press a key that is appropriate for the task you are performing, the
transceiver makes a valid beep. When you press an inappropriate key, the transceiver
makes an error beep.
Default value: Enabled