OPERATING THE TRANSCEIVER
CALLING
ENVOY™ TRANSCEIVER REFERENCE MANUAL 47
Related links:
Call Key Options on page 207
Making a Selective call on page 48
Making a Channel Test call on page 50
Making a Message call on page 53
Making a Phone call on page 56
Making a Send Position call on page 57
Making a Get Position call on page 58
Making a Get Status call on page 60
Making an Emergency call on page 62
Making an RFDS Emergency call on page 63
Making a Marine Emergency call on page 64
Making an ALE Sounding call on page 65
Making a call from the Emergency key
You can set up an emergency contact with calls that are chained together when you
hold the key. Emergency contacts are set up in User Data > Contacts >
Emergency Contacts.
CAUTION: If you have more than one emergency contact, you will be prompted to
select the emergency contact that you want to call at the time of the call.
To make a call from the Emergency key:
1 Hold for 2 sec.
1 If you have more than one emergency contact, scroll to the contact who you
want to call, then press CALL.
1 If prompted, press or to scroll to the channel that you want to use, then
press CALL.
A is shown next to the currently selected channel/mode.
To abort the call before it is answered, press PTT or SCAN.
There will be audible beeps or a pop-up message to indicate that the call has
been successful.
Related links:
Overview of contacts on page 158
Adding a contact on page 163
Chain call on page 159
To Next Page
Loading...
Need help?
General
