OPERATING THE TRANSCEIVER
USING GPS
74 E
NVOY™ TRANSCEIVER REFERENCE MANUAL
Distance and bearing
The Envoy™ Transceiver calculates distance and bearing information between your
GPS information (last fix from GPS receiver or information entered into Settings >
GPS > My Position), and a waypoint that you select from a Get/Send Position call
in the Call History or Contacts.
Figure 18: Distance and bearing
Setting a waypoint for distance and bearing
NOTE: You can set a waypoint if the GPS Call option is installed.
To set up a waypoint:
1 From the main menu, select (General), then (GPS).
1 Press to move to the Distance and Bearing tab.
1 Press (Waypoint), then press to select the Call History or Contacts
tab as required.
The information available is filtered on Get Position calls and received Send
Position calls.
1 Press or to scroll to the call or contact containing the GPS information that
you want to use for the waypoint, then press OK.
1 If you are setting the waypoint from a Get Position call for a contact,
press CALL to update the position, if required.
1 Press (Close).
To Next Page
Loading...
Need help?
General
