COMPLIANCE
OVERVIEW
470 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Overview
This section describes how to ensure the Envoy™ Transceiver complies with the
European R&TTE Directive 1999/5/EC.
This section also contains the requirements for FCC, IC, and RCM.
European R&TTE Directive
The Envoy™ Transceiver has been tested and complies with the following standards
and requirements (articles of the R&TTE Directive):
• Article 3.1b: ETSI EN 301 489-1 V1.8.1
• Article 3.1b: ETSI EN 301 489-15 V1.2.1
• Article 3.2: Australian type approval according to AS/NZS 4770:2000 +
transmitter RSE tests to the limits specified in Annex 6, section 6.1.2 of
CEPT/ERC/Recommendation 74-01E
• Article 3.1a: assessed against ICNIRP and FCC requirements
• Article 3.1a: (LVD) EN 60950-1:2006/AC:2011
• Article 3.1a: (MPE) EN 62311:2008
Product marking and labelling
Any equipment supplied by Codan that satisfies these requirements is identified by the
markings displayed on the product.
Radiation safety (EU installations only)
To ensure optimal transceiver performance and to avoid exposure to excessive
electromagnetic fields, the antenna system must be installed according to the
instructions provided.
WARNING: High voltages exist on the antenna during transmission and tuning. Do
not touch the antenna during these activities. RF burns may result.
WARNING: Install the earthing system or counterpoise as directed to prevent RF
burns from any metal part of the transceiver.
WARNING: You should not transmit from your transceiver or tune the antenna
unless people are beyond the safe working distance for the installation.
To Next Page
Loading...
Need help?
General
