Codan Envoy - Editing a Channel

CHANNELS
WORKING WITH CHANNELS
ENVOY™ TRANSCEIVER REFERENCE MANUAL 125
1 Press or to select the value that you want to use from the following:
• To transmit at the power level set in the Tx Power entry, select Leave
as is.
• To transmit signals at the value set for the low power range, select Low.
• To transmit signals at the value set for the medium power range, select
Medium.
• To transmit signals at the value set for the high power range, select High.
1 Press to move to the Antenna entry.
NOTE: The Antenna entry is used to select one of two antennas when
the Dual Antenna Adaptor is connected to the transceiver.
1 Press or to select the value that you want to use from the following:
• To assign antenna 1 to this channel, select 1.
• To assign antenna 2 to this channel, select 2.
NOTE: The actual antenna that is used during scanning is
antenna 1 by default, however, this may be changed
depending on how the antennas are assigned to the scanned
channels.
1 If you want to review the information that you have entered, press or to
move through the entries.
1 Press (Save) to save the information.
Related links:
Antenna on page 121
Editing a channel
Editing a channel is similar to adding a channel.
To edit a channel:
1 From the main menu, select (User Data), then (Channels).
1 Press or to scroll to the channel that you want to edit, then press OK.
1 Continue with the process for adding a channel.
Related links:
Adding a channel on page 123