SETTINGS
SETTINGS > CALLING > GENERAL
ENVOY™ TRANSCEIVER REFERENCE MANUAL 231
Call Types For New Call
The Call Types For New Call entry sets the call types that are available for
selection when making a new call.
Available values: Selective, Channel Test, Message, Get Position, Send Position,
Phone, Get Status, Emergency, RFDS Emergency, Marine Emergency, ALE
Sounding
NOTE: The call types available depend on the options installed in your
transceiver.
Default value: all available call types selected
Related links:
Call types on page 434
Show Phone Link Address
The Show Phone Link Address entry sets whether or not the address of a phone
link is shown on the screen during a Phone call.
A phone link is the information defining the connection of a remote HF transceiver to
a telephone station. A telephone station comprises a transceiver system and a
radio/telephone interconnect unit that can route Phone calls from HF transceivers to
the public telephone network. The address setting in a phone link is the address of the
transceiver connected to the radio/telephone interconnect, or the address of the
radio/telephone interconnect.
Default value: Disabled
Related links:
Adding a phone link on page 154
Emergency Call Alarm
The Emergency Call Alarm entry sets the delay between receiving an Emergency
call and sounding the external alarm.
The external alarm is a relay that can be wired by a user to ring a bell or to sound a car
horn. By default, the external alarm relay reacts immediately, continuing for five
minutes.
Available values: Never, Immediate, 10 sec, 30 sec
Default value: Immediate
Related links:
15-way GPIO connector on page 368
To Next Page
Loading...
Need help?
General
