SETTINGS
SETTINGS > SCAN
ENVOY™ TRANSCEIVER REFERENCE MANUAL 229
Scan Mute
The Scan Mute entry sets the mute type used when the Auto Resume Mode entry
is set to Start Scan.
If you want the transceiver to:
• scan for voice and calls addressed to your station, select Voice and calls
• scan only for calls addressed to your station, select Calls
• scan according to the current mute state, select Leave as is
Default value: Calls
Scan Voice Extend
The Scan Voice Extend entry sets the period of time that the transceiver pauses
scan when voice is detected. The transceiver continues to extend by this amount each
time voice is detected on the channel, up to the maximum hold period set in the Scan
Voice Max Pause entry.
If you do not want the transceiver to pause scan after voice is detected, set this entry
to 0.
Range: 0 to 30 sec
Default value: 5sec
Scan Voice Max Pause
The Scan Voice Max Pause entry sets the maximum length of time that the
transceiver pauses on a channel after voice is detected.
Range: 0 to 120 sec
Default value: 5sec
To Next Page
Loading...
Need help?
General
