SETTINGS
SETTINGS > SCAN
228 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Settings > Scan
The scan settings enable you to set how the transceiver scans, what happens after a
period of inactivity or the end of a call, and how the mute behaves when voice is
detected.
Related links:
Auto Resume Mode on page 228
Auto Resume Time on page 228
Scan Mute on page 229
Scan Voice Extend on page 229
Scan Voice Max Pause on page 229
Auto Resume Mode
The Auto Resume Mode entry sets the action performed when the auto resume
time ends.
The transceiver may be set to automatically begin a task when scanning is switched
off and there has been no PTT, channel change, scan on/off, mute on/off, or call
sending activity for a certain length of time.
If you want the transceiver to:
• remain on a channel, select Disabled
• close the link to end any call in progress and, if it was scanning prior to the call,
resume scanning, select Close link
• start scanning, select Start scan
Default value: Start scan
Auto Resume Time
The Auto Resume Time entry sets the length of time after no activity that the
transceiver performs the action set in the Auto Resume Mode entry.
Range: 1 to 20 min
Default value: 2min
To Next Page
Loading...
Need help?
General
