USING THE WIZARD
USING THE WIZARD
ENVOY™ TRANSCEIVER REFERENCE MANUAL 21
Selecting a peripheral device
When you select the peripheral device from the list, the transceiver automatically sets
these properties.
NOTE: Codan peripheral devices are listed by their type number, for example,
3031 Crosspatch. The type number for a Codan device is located on the
front or serial number escutcheon.
To select a peripheral device:
1 Press or to scroll to the type of peripheral device that is attached to the
connector, then press OK.
If there are settings that you can change to optimise this peripheral for your
requirements, is shown to the right of the peripheral name when it is selected.
1 If you want to change settings for the peripheral, press to see the list of entries
that you may change.
If the value of an entry for a peripheral device has been changed from the default
value, is shown next to the title of the entry.
1 Press (Save) to automatically update settings for correct operation of the
connected peripheral device.
1 Press OK to close the wizard.
1 If you added a peripheral device, restart your transceiver to activate the new
settings.
To Next Page
Loading...
Need help?
General
