COMPLIANCE
FCC COMPLIANCE
ENVOY™ TRANSCEIVER REFERENCE MANUAL 475
FCC compliance
FCC Part 90 certification
The Envoy™ Transceiver has been tested and certified to FCC Part 90 (FCC identifier
code DYY2210).
FCC Part 15 compliance
Any modifications made to the Envoy™ Transceiver and 3020 Transceiver Supply
that are not approved by the party responsible for compliance may void your
equipment’s compliance under Part 15 of the FCC rules.
The Envoy™ Transceiver and 3020 Transceiver Supply have been tested and found
to comply with the limits for a Class B device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by switching the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• reorient or relocate the receiving antenna
• increase the separation between the equipment and receiver
• connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
• consult the dealer or an experienced radio/TV technician for help
To Next Page
Loading...
Need help?
General
