SETTINGS
SETTINGS > CONNECTIVITY
258 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Settings > Connectivity
The connectivity settings enable you to modify the network connectivity settings for
non-standard or complex Envoy™ installations.
Related links:
IP Address on page 258
Alias on page 258
Network Mask on page 258
DHCP Client on page 259
Default Gateway on page 259
USB IP Address on page 259
USB Network Mask on page 259
USB DHCP Server on page 259
RFU IP Address on page 260
RFU Alias on page 260
RFU Network Mask on page 260
RFU DHCP Client on page 260
RFU Default Gateway on page 260
IP Address
The IP Address entry sets the IPv4 address for the control point. If you have
multiple control points for an RFU, you must set a different IP address for each control
point, or enable the DHCP clients in the control point and RFU. If you have set the
DHCP Client entry to Enabled, this entry is ignored.
Default value: 192.168.0.249 (handset), 192.168.0.247 (desk console)
Related links:
DHCP Client on page 259
RFU DHCP Client on page 260
Alias
The Alias entry sets the network alias for this control point. If you have multiple
control points connected to an RFU, you can identify them with a meaningful name.
Default value: CP
Network Mask
The Network Mask entry sets the network mask for the control point. If you have
set the DHCP Client entry to Enabled, this entry is ignored.
Default value: 255.255.255.0
To Next Page
Loading...
Need help?
General
