USING THE WIZARD
USING THE WIZARD
20 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Completing the contact
To finish entering the information required for the contact:
1 Press to move to the Call Description entry.
The call type is entered automatically as the call description.
1 Enter a new description for this call, if required.
1 Press (Save) to save the information.
1 If you want to add another call for the contact, press (Yes), then repeat the
steps for adding a call.
If you do not want to add another call, press (No).
1 If you want to add another contact, press (Yes), then repeat the steps for
adding a contact.
If you do not want to add another contact, press (No).
1 Do one of the following:
• If you want to select an antenna, continue from Selecting an antenna on
page 20.
• If you do not want to select an antenna, press (Close), then continue
from Selecting a peripheral device on page 21.
Related links:
Adding a contact on page 17
Selecting an antenna
Each type of antenna has a specific requirement for tuning, and the transceiver uses a
different protocol for each one. You must select the type of antenna that is used in your
station so that the transceiver knows how to tune the antenna. Some antennas, such as
broadband antennas, do not require tuning.
To select an antenna:
1 Press or to scroll to the antenna type that you want to use, then press OK.
1 Press (Save) to save the information.
1 Do one of the following:
• If you want to connect an accessory to the 15-way connector of the RFU,
press (Yes), then continue from Selecting a peripheral device on
page 21.
• If you do not want to connect an accessory, press (No), then
press OK to close the wizard.
To Next Page
Loading...
Need help?
General
