To Next Page

To Previous Page

USING THE WIZARD

ENVOY™ TRANSCEIVER REFERENCE MANUAL 17

NOTE: The wizard automatically allocates this self address to the default

HF networks: Selcall and CALM (if FED-STD-1045 ALE or

MIL-STD-188-141B ALE option is installed).

1 Do one of the following:

• If you want to add a contact, press (Yes), then continue from Adding

a contact on page 17.

• If you do not want to add a contact, press (No), then continue from

Selecting an antenna on page 20.

Adding a contact

A contact is a person or organisation that you want to call, and for which you want to

pre-define the method of calling. You may be able to contact the same person or

organisation via a number of different methods. When you set up the contact, you

define each method as a separate call for the contact.

NOTE: If you require more detail on adding a contact, see Contacts on

page 157.

To add a contact:

1 Enter the name that you want to use for the contact, then press (Add Call).

The HF Network entry is highlighted.

The HF network defines the call system and self address that is used by your

station when the call is made. For example, if you are using a Selcall HF

network, you must select a channel for the call. If you are using a CALM HF

network, you may either select a channel or let the transceiver select a channel

for the call.

1 Press or to select the HF network that you want to use.

1 Press to move to the Call Type entry.

1 Press or to select the call type that you want to use.

NOTE: The call type that you select affects information that you can

enter for the remainder of this call.

1 If you are adding:

• a Selective, Channel Test, Emergency, Get Position or Send Position call,

continue from Adding a simple call on page 18

• a Message call, continue from Adding a Message call on page 18

• a Phone call, continue from Adding a Phone call on page 19

Codan Envoy Reference Manual

Other manuals for Codan Envoy