To Next Page

To Previous Page

USING THE WIZARD

16 ENVOY™ TRANSCEIVER REFERENCE MANUAL

1 Do one of the following:

• If you want to add a scan table, press (Yes).

• If you do not want to add a scan table, press (No), then continue from

Entering a self address on page 16.

1 Do one of the following:

• If you want to scan all of the channels in the transceiver that have a USB

mode, press (Yes), then continue from Entering a self address on

page 16.

• If you want to choose the channels and modes that you want to scan,

press (No), then continue from Adding channels to a scan table on

page 16.

Related links:

Overview of scan tables on page 128

Overview of HF networks on page 140

Adding a channel on page 123

Adding channels to a scan table

To add channels to a scan table:

1 Press or to scroll to the channel that you want to add, then press OK.

1 Press or to select the mode that you want to use.

1 Select more channels, as required.

1 Press (Save) to add these channel selections.

1 Continue from Entering a self address on page 16.

Entering a self address

A self address is used by other stations to call your station. For example, if the self

address of your station is 1234, operators at other stations enter the address 1234 when

they want to make a call to you.

To enter a self address:

1 Enter the address that you want to use.

You can enter up to six digits.

NOTE: Addresses ending in 99 and 00 have a special function in Selcall

HF networks.

1 Press (Save) to save the information.

Codan Envoy Reference Manual

Other manuals for Codan Envoy