OPERATING THE TRANSCEIVER
SCANNING CHANNELS
34 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Switching scanning on or off
To switch scanning on or off:
1 Press SCAN.
If a call is not in progress, scanning is toggled on or off.
If a call is in progress, the call is ended and the transceiver begins scanning.
If a call from a modem (or any other peripheral device) is in progress, you are
prompted to break the system lock to resume scanning.
NOTE: When scanning is switched on, mute is also switched on.
NOTE: If you press PTT while the transceiver is scanning, the scan is
stopped.
Pausing scanning
To pause scanning:
1 Do one of the following:
• To pause scanning on the last-selected channel, press OK.
• To pause scanning and scroll to another channel, press or .
The channel/modes through which you can scroll are those in the scan tables
that are being scanned. They are not listed alphabetically but in the order in
which they are being scanned.
If you do not press a key within 30 sec, the transceiver automatically resumes
scanning.
1 While scanning is paused, do one of the following:
• To speak on the selected channel, hold down PTT.
• To resume scanning immediately, press OK.
• To stop scanning completely, press SCAN.
To Next Page
Loading...
Need help?
General
