SETTINGS
SETTINGS > SECURITY
256 ENVOY™ TRANSCEIVER REFERENCE MANUAL
General Options
The General Options entry sets options for all encryptors.
You may select any of the following actions:
• To enable the user to select the encryptor type via hold SEC (2220/2230), or the
Secure Info function (2221), select Allow user to select encryptor type.
• To enable the user to erase CES secure keys and AES secure keys using the
+ SEC hot-key sequence (2220/2230) or Functions > Power Plus
Macros > Secure Erase (2221), select Hot-key sequence to erase
keys.
• To prevent the user from exiting secure mode, select Always secure.
Default value: Allow user to select encryptor type
Secure Start State
The Secure Start State entry sets the secure state of the transceiver at power up.
If you want the transceiver to:
• return to the secure state it was in prior to the transceiver being switched off then
on again, select Leave as is
• go secure at power up, select Secure on
• remain clear at power up, select Secure off
Default value: Leave as is
CES Options
The CES Options entry sets the operational settings for the CES voice encryptor.
You may select multiple actions.
If you want to:
• enable the use of a PIN for private communication within an organisation, select
Session PIN entry
• hear all communications in clear mode, but switch to secure when an encrypted
transmission is detected from another station that is in secure mode, or you press
PTT, select Secure standby
• enable secure standby mode and allow transmissions in clear, select Clear Tx
during standby
Default value: no selection
To Next Page
Loading...
Need help?
General
