FREE TUNE
SELECTING A FREE-TUNE FREQUENCY
ENVOY™ TRANSCEIVER REFERENCE MANUAL 285
Selecting a free-tune frequency
The free-tune function in the transceiver provides the ability to scroll up and down
through the frequency range to tune to the frequency that you want, or enter the exact
frequency on which you want to tune.
To select a free-tune frequency:
1 Go to the channel screen.
1 If the transceiver is scanning, press SCAN to switch off scanning.
1 If you are using a 2220 Handset or 2230 Desk Console, press
FREE Rx.
1 If you are using a 2221 Handset:
•Press (Options).
• Press or to scroll to the Free Tune Screen function.
•Press (Select).
1 If you want to listen for traffic on the frequency, ensure that mute is switched
off.
1 Do one of the following:
• If you want to scroll to a free-tune frequency that is accurate to a fraction
of a kilohertz (up to 3 decimal points), use , , or to scroll to the
frequency.
NOTE: You cannot change the volume of the signal that you are
receiving.
• If you want to enter a free-tune frequency, press (Select) until the
existing frequency is highlighted, then use the numeric keys to enter the
frequency that you want to use, up to 2 decimal places.
NOTE: If you are using a 2221 Handset, press OK to access the
virtual keypad.
To Next Page
Loading...
Need help?
General
