PERIPHERALS
ENTRIES FOR A PERIPHERAL
198 ENVOY™ TRANSCEIVER REFERENCE MANUAL
RFU 15way Speed
The RFU 15way Speed entry sets the data rate of the RS232 15-way serial port. If
available, you should set this to the same speed that is set in the connected peripheral
device.
Default value: 9600 bit/s
RFU 15way Startup
The RFU 15way Startup entry sets the serial commands that you want to have
performed by the 15-way port following power up.
Typically, this is used for specific commands that are required in a system that uses
CICS commands.
Default value: no selection
RFU Average ALC
The RFU Average ALC entry sets whether or not the transmit output power for the
RFU is averaged. If it is set to Disabled, the peak output power is used.
Default value: Enabled
RFU ALC Rate
The RFU ALC Rate entry sets the ALC time constant.
If you want the transceiver to send:
• optimised voice signals, select Voice (Fast)
• optimised data signals, select Data (Hold)
Default value: Data (Hold)
RFU Audio Type
The RFU Audio Type entry sets the type of audio for the RFU.
If the transceiver is being used for:
• low distortion audio, select Data
• fast, compressed audio, select Voice
Default value: Data
To Next Page
Loading...
Need help?
General
