SETTINGS
SETTINGS > CONFIGURATION > GENERAL
222 ENVOY™ TRANSCEIVER REFERENCE MANUAL
High Power
The High Power entry enables you to set the power level that is used when the Tx
Power entry is set to High.
Range: 61 to 125 watt
Default value: 125 watt
Related links:
Tx Power on page 221
Easitalk Start State
The Easitalk Start State entry sets the state of Easitalk™ at power up.
If you want the transceiver to:
• return to the state it was in prior to the transceiver being switched off then on
again, select Leave as is
• never use Easitalk™ at power up, select Disabled
•always use Easitalk™ at power up, select Enabled
Default value: Leave as is
Default Selcall
The Default Selcall entry sets the default Selcall call system when adding HF
networks.
Available values: Codan, Open
Default value: Codan
Handset AGC
The Handset AGC entry sets the rate of action of AGC for the input signal to the
handset.
To optimise AGC for:
• voice signals, select Slow
• special modes and morse code in a noisy environment, select Fast
• voice and linear data signals, select Hold
Default value: Hold
To Next Page
Loading...
