IP REMOTE CONTROL
LAN CONNECTION
292 ENVOY™ TRANSCEIVER REFERENCE MANUAL
LAN connection
A LAN connection may be used in the following situations:
• The transceiver system, with multiple RFUs, is located at one site where a LAN
infrastructure and network access points are available.
This installation may be used in multi-storey buildings that are pre-wired for
LAN communications.
• The distance between the desk console and the RFU(s) is greater than 30 m.
If the desired operating location is greater than 30 m from the antenna
installation where the RFU is co-located, the direct 8-way to 10-way cable
(08-07205-030) cannot be used.
CAUTION: Long RF cable runs between the RFU and antenna can be used,
but cable losses degrade the signal.
• Multiple control points are required for the same RFU.
NOTE: All control points in this case use the same HF station address.
This connection uses the transceiver to Ethernet adaptor cable (08-07215-001).
To Next Page
Loading...
