SETTINGS
SETTINGS > CONTROL POINT > CONSOLE
218 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Console PTT
The Console PTT entry sets the audio source for the PTT on the desk console to
either an internal or external microphone.
Default value: Internal microphone
Foot-switch PTT
The Foot-switch PTT entry sets the audio source for the foot-switched PTT on the
desk console to either an internal or external microphone.
Default value: Internal microphone
Console External Alarm
The Console External Alarm entry sets whether the alarm output on the 15-way
port of the desk console is enabled or disabled.
The external alarm is a relay that can be wired by a user to ring a bell or to sound a car
horn.
Default value: Enabled
Console Easitalk Start State
The Console Easitalk Start State entry sets the state of Easitalk on the desk
console at power up.
If you want the desk console to:
• return to the state it was in prior to the desk console being switched off then on
again, select Leave as is
• never use Easitalk™ at power up, select Disabled
•always use Easitalk™ at power up, select Enabled
Default value: Leave as is
To Next Page
Loading...
