USING THE WIZARD
USING THE WIZARD
14 ENVOY™ TRANSCEIVER REFERENCE MANUAL
1 Press or to select the format that you want to use.
1 If you want to review the information that you have entered, press or to
move through the entries.
1 Press (Save) to save the information.
If you have not changed any of the time and date information, press
(Close).
Related links:
Setting the time and date on page 40
Setting the location of the desk console
NOTE: This step in the wizard is shown if your control point is a desk console.
To set the location of the desk console:
1 Press or to select the value that you want to use from the following:
• If the desk console is connected to the RFU using cable 08-07205-00x,
select Local.
• If the desk console is connected to the RFU using an Ethernet cable
(08-07215-001), select Remote.
CAUTION: You must set this value correctly to ensure that the desk console
switches off and on.
1 Press (Save) to save the information.
If you have not changed the location of the desk console, press (Close).
Related links:
Setting the location of the desk console on page 43
To Next Page
Loading...
