OPERATING THE TRANSCEIVER
CALLING
60 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Making a Get Status call
If you want to obtain information on the status of a transceiver at a specific station,
such as the power output of the transmitter or the firmware versions installed, make a
Get Status call to that station. Get Status calls are automatically answered by the
receiving station so an operator is not required to process the return call.
NOTE: The success of your Get Status call depends upon the value set in
Calling > General > Respond OTA of the transceiver you are
calling and the privacy mode of the HF network that you are using for
the call.
To make a Get Status call:
1 Press CALL.
The call type and address of the last call are shown at the top of the call screen.
The filtered call log below this shows the latest instance of any call type made
to or received from a particular address.
1 If you do not want to use the HF network shown at the top right of the screen:
•Press (Options).
• Scroll to HF Networks, then press (Select).
• Scroll to the HF network that you want to use, then press OK.
1 Press or to select the Get Status call type if it is not selected.
1 Do one of the following:
• To repeat the call to the last address used, press CALL.
• To call a different station, enter the address, then press CALL.
• To repeat or return a call from the Call Log, press to scroll to the call,
press or to select your required call type, then press CALL.
To Next Page
Loading...
Need help?
General
