OPERATING THE TRANSCEIVER
CALLING
ENVOY™ TRANSCEIVER REFERENCE MANUAL 63
1 Do one of the following:
• To repeat the call to the last address used, press CALL.
• To call a different station, enter the address, then press CALL.
• To repeat or return a call from the Call Log, press to scroll to the call,
press or to select your required call type, then press CALL.
• To use an ALE address syntax in an ALE/CALM HF network, press
(View), scroll to ALE, press (Select), scroll to the syntax that you
want to use, then press CALL.
1 If prompted, press or to scroll to the channel that you want to use, then
press CALL.
A is shown next to the currently selected channel/mode.
To abort the call before it is answered, press PTT or SCAN.
There will be audible beeps or a pop-up message to indicate that the call has
been successful.
Related links:
Emergency call on page 436
Entering text in a field on page 103
Using multiple addresses for calls in an ALE/CALM HF network on page 453
Group calls in a Codan Selcall HF network on page 452
My Position on page 252
Making a call from the Emergency key on page 47
GPS Show Options on page 250
Making an RFDS Emergency call
NOTE: The RFDS Emergency call type is available in Australia only, and uses
the RFDS call system and specific RFDS channels.
If you want to trigger an emergency alert tone at an RFDS station, make an RFDS
Emergency call.
To make an RFDS Emergency call:
1 Press CALL.
The call type and address of the last call are shown at the top of the call screen.
The filtered call log below this shows the latest instance of any call type made
to or received from a particular address.
To Next Page
Loading...
Need help?
General
