OPERATING THE TRANSCEIVER
CALLING
ENVOY™ TRANSCEIVER REFERENCE MANUAL 49
1 If you do not want to use the HF network shown at the top right of the screen:
•Press (Options).
• Scroll to HF Networks, then press (Select).
• Scroll to the HF network that you want to use, then press OK.
1 Press or to select the Selective call type if it is not selected.
NOTE: If you want to test the quality of the channel before you make the
actual call, hold CALL first.
1 Do one of the following:
• To repeat the call to the last address used, press CALL.
• To call a different station, enter the address, then press CALL.
• To repeat or return a call from the Call Log, press to scroll to the call,
press or to select your required call type, then press CALL.
• To use an ALE address syntax in an ALE/CALM HF network, press
(View), scroll to ALE, press (Select), scroll to the syntax that you
want to use, then press CALL.
1 If prompted, press or to scroll to the channel that you want to use, then
press CALL.
A is shown next to the currently selected channel/mode.
To abort the call before it is answered, press PTT or SCAN.
There will be audible beeps or a pop-up message to indicate that the call has
been successful.
Related links:
Selective call on page 440
Entering text in a field on page 103
Using multiple addresses for calls in an ALE/CALM HF network on page 453
Group calls in a Codan Selcall HF network on page 452
To Next Page
Loading...
Need help?
General
