Lexmark 7462 series - Page 67

201 error messages
Error code Description Action
201.00 Sensor (fuser output) area jam (type 1 fuser)
The media is jammed in the sensor (fuser output)
area.
Go to
“Sensor (fuser output) service check” on
page 82.
201.01 Main drive motor assembly load error (type 1 fuser)
The main drive motor assembly has failed or
caused high mechanical load due to paper jam or
bind.
Go to
“Main drive motor assembly load error
service check” on page 80.
201.02 Sensor (fuser output) late jam (type 1 fuser)
The media is late reaching the sensor (fuser
output) within the specified time.
Go to
“Sensor (fuser output) late jam service
check” on page 83.
201.03 Image data did not start in time (type 1 fuser)
Printhead write failure
Go to
“Printhead write failure service check”
on page 85.
201.04 Sensor (narrow media) late jam (type 1 fuser)
The expected wide media is late reaching the
sensor (narrow media) within the specified time.
Go to
“Sensor (narrow media) late jam service
check” on page 78.
201.06 Sensor (narrow media) late jam (type 1 fuser)
The expected wide media is late reaching the
sensor (narrow media) within the specified time.
201.07 Sensor (fuser output) late jam (type 1 fuser)
The media is late reaching the sensor (fuser
output) within the specified time.
Go to
“Sensor (fuser output) late jam service
check” on page 83.
201.25 Sensor (fuser output) late jam (type 2 fuser)
The media is jammed in the sensor (fuser output)
area.
201.26 Main drive motor assembly load error (type 2
fuser)
The main drive motor assembly has failed or
caused high mechanical load due to paper jam or
bind.
Go to
“Main drive motor assembly load error
service check” on page 80.
201.27 Sensor (fuser output) late jam (type 1 fuser)
The media is late reaching the sensor (fuser
output) within the specified time.
Go to
“Sensor (fuser output) late jam service
check” on page 83.
201.28 Image data did not start in time (type 2 fuser)
Printhead write failure
Go to
“Printhead write failure service check”
on page 85.
201.29 Sensor (narrow media) late jam (type 2 fuser)
The expected wide media is late reaching the
sensor (narrow media) within the specified time.
Go to
“Sensor (narrow media) late jam service
check” on page 78.
7462
Diagnostic information
67