Lexmark X95 series - Sensor (ADF Scan Width 1) Static Jam

Diagnostic information 2-161
7558-xxx
Go Back
Previous
Next
287.01 Sensor (ADF scan width 1) static jam
5
Check the sensor (ADF inverter)
for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch ADF/SCANNER
SENSOR TESTS.
4. Touch Sensor (ADF
inverter).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 7. Go to step 6.
6
Check the sensor (ADF inverter)
for proper connection.
Is the above component
properly connected?
Replace the sensor (ADF
inverter). Go to “Sensor (ADF
inverter) removal” on
page 4-244.
Replace the connections.
7
Check the ADF registration motor
for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch ADF/SCANNER
MOTOR TESTS.
4. Touch ADF registration
motor.
Does the above component
operate properly?
Go to step 9. Go to step 8.
8
Check the ADF registration motor
for proper connection.
Is the above component
properly connected?
Replace the ADF registration
motor. Go to “ADF registration
motor removal” on page 4-218.
Replace the connections.
9
Place an undamaged document
in the ADF, and perform an ADF
test.
Does the error remain?
Replace the ADF controller
PCBA. Go to “ADF controller
PCBA removal” on page 4-203.
Problem resolved
Step Action and questions Yes No
1 Check the media path.
Is the media path free of any
media or media fragments?
Go to step 2. Remove any media or media
fragments.
Step Action and questions Yes No