Lexmark X95 series - Sensor (MPF Feed Out) Lag Jam; Next

2-132 Service Manual
7558-xxx
Go Back
Previous
Next
250.05 Sensor (MPF feed out) lag jam
9
Check the the HCF controller
card PCBA for proper connection.
Is the above component
properly connected?
Replace the HCF controller card
PCBA. Go to “HCF controller
card PCBA removal” on
page 4-429.
Go to step 10.
Replace the connections.
10
POR the machine, and perform a
print test. Go to “PRINT TESTS”
on page 3-25.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Problem resolved
Step Action and questions Yes No
1 Check the media path.
Is the media path free of any
media fragments?
Go to step 2. Remove any media or media
fragments.
2
Check the MPF rollers for wear.
Is the MPF feed/pick roller
assembly free of excess wear?
Go to step 3. Replace the MPF feed roller. Go
to “MPF roller removal” on
page 4-127.
3
Check the sensor (MPF feed out)
for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch PRINTER SENSOR
TESTS.
4. Touch Sensor (MPF feed
out).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 5. Go to step 4.
4
Check the sensor (MPF feed out)
for proper connection.
Is the above component
properly connected?
Replace the sensor (MPF feed
out). Go to “MPF tray feeder
removal” on page 4-128.
Step Action and questions Yes No