Lexmark X95 series - Heat Belt (Center) Temperature Increase Failure; Heat Belt (Rear) Temperature Increase Failure; Fuser Temperature Lag Error

2-58 Service Manual
7558-xxx
Go Back
Previous
Next
121.07 Heat belt (center) temperature increase failure
121.08 Heat belt (rear) temperature increase failure
121.09 Fuser temperature lag error
Step Action and questions Yes No
1 Check the fuser assembly.
Is the above component
properly connected?
Go to step 2. Remove foreign particles, and
replace the connections.
2
Replace the fuser assembly. Go
to “Fuser assembly removal”
on page 4-84.
Does the error remain?
Go to step 3. Problem resolved
3
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Problem resolved
Step Action and questions Yes No
1 Check the fuser assembly.
Is the above component
properly connected?
Go to step 2. Remove foreign particles, and
replace the connections.
2
Replace the fuser assembly. Go
to “Fuser assembly removal”
on page 4-84.
Does the error remain?
Go to step 4. Problem resolved
3
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Problem resolved
Step Action and questions Yes No
1 Check the fuser assembly.
Is the above component
properly connected?
Go to step 2. Remove foreign particles, and
replace the connections.
2
Replace the fuser assembly. Go
to “Fuser assembly removal”
on page 4-84.
Does the error remain?
Go to step 3. Problem resolved