Lexmark X95 series - C Toner Auger Removal

Repair information 4-35
7558-xxx
Go Back
Previous
Next
8. Remove the six screws (D) securing the bracket.
9. Gently detach the bridge PCBA from the upper engine PCBA.
10. Remove the bracket.
11. Remove the three screws (E) securing the bridge PCBA to the bracket.
12. Remove the bridge PCBA.
C toner auger removal
1. Remove the printer front door. See “Printer front door removal” on page 4-13.
2. Remove the transfer belt cleaner. See “Transfer belt cleaner removal” on page 4-178.
3. Remove the waste toner box.
4. Remove the four photoconductor units.
5. Remove the four toner supplies.
6. Remove the operator panel front cover. See “Operator panel front cover (MFP) removal” on page 4-8.
7. Remove the printhead retract door. See “Printhead retract door removal” on page 4-145.
8. Remove the inner cover. See “Inner cover removal” on page 4-4.
9. Remove the inner plate. See “Inner plate removal” on page 4-98.