Lexmark X95 series - Sensor (ADF Closed Interlock) Removal; Sensor (ADF Document Set) Removal

4-242 Service Manual
7558-xxx
Go Back
Previous
Next
6. Disconnect the cable (B).
Sensor (ADF closed interlock) removal
1. Remove the operator panel assembly. See “Scanner controller PCBA removal” on page 4-238.
2. Remove the screw (A).
3. Release the harness (B) from the clamp.
4. Disconnect cable (C) to remove the sensor (ADF closed interlock).
Sensor (ADF document set) removal
1. Remove the ADF rear cover. “ADF main drive sub assembly removal” on page 4-215
2. Disconnect the cable (A).