Lexmark X95 series - Flatbed Scanner Assembly Removal

4-230 Service Manual
7558-xxx
Go Back
Previous
Next
6. Remove the FB CCD sensor assembly.
Flatbed scanner assembly removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-19.
2. Remove the ADF assembly. See “Automatic document feeder (ADF) assembly removal” on
page 4-227.
3. Remove the scanner rear cover. See “Scanner rear cover removal” on page 4-20.
4. Remove the operator panel left cover. See “Operator panel left cover removal” on page 4-10.
5. Remove the operator panel right cover. See “Operator panel right cover removal” on page 4-11.
6. Remove the scanner right cover. See “Scanner right cover removal” on page 4-21.
7. Remove the scanner left cover. See “Scanner left cover removal” on page 4-19.
8. Remove the operator panel. See “Scanner controller PCBA removal” on page 4-238.
9. Remove the five screws (A) from the right side of the printer.
A