Lexmark X95 series - Sensor (Stacker bin Level R) Removal; Sensor (Stacker bin Level Encoder) Removal

4-402 Service Manual
7558-xxx
Go Back
Previous
Next
Sensor (stacker bin level R) removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-348.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-380.
3. Disconnect the connector from the lift tray height sensor (stacker bin level R) (A).
4. Remove the screw securing the sensor (stacker bin level R) (A).
5. Remove the sensor (stacker bin level R) (A).
Sensor (stacker bin level encoder) removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-380.
2. Disconnect the connector from the sensor (stacker bin level encoder) (A).
3. Release the harness from the clamp.
4. Remove the screw securing the bracket (B) from the stacker bin lift motor assembly (C).
A
Rear
Connector
A
B
C
Rear
Clamp
Clamp
Connector