Lexmark X95 series - Sensor (Booklet Media Entrance) Lag Jam

Diagnostic information 2-235
7558-xxx
Go Back
Previous
Next
491.05 Sensor (booklet media entrance) lag jam
Step Action and questions Yes No
1 Check the sensor (booklet media
entrance) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
3. Touch Sensor (booklet media
entrance).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to Step 3. Go to Step 2.
2
Check the sensor (booklet media
entrance) for proper connection.
Is the above component
properly connected?
Replace the sensor (booklet
media entrance).
Go to “Sensor (booklet media
entrance) removal” on
page 4-386.
Replace connections.
3
Check the booklet entrance
motor for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Booklet entrance
motor.
Does the above component
operate properly?
Go to step 5. Go to step 4.
4
Check the booklet entrance
motor for proper connection.
Is the above component
properly connected?
Replace the booklet entrance
motor.
Go to “Booklet media entrance
drive motor removal” on
page 4-329.
Replace connections.
5
Check the booklet unit interface
contact for proper connection.
Is the above component
properly connected?
Go to Step 6. Replace the booklet unit interface
contact.
6
Check the booklet controller card
assembly for proper connection.
Is the above component
properly connected?
Replace the booklet controller
card assembly).
Go to “Booklet controller card
assembly removal” on
page 4-322.
Go to step 7.
Replace the connections.