Repair information 4-357
7558-xxx
9. Remove the finisher docking bracket (D).
Reinstallation note: When docking the finisher to the printer, make sure the boss on the finisher docking
bracket (D) is inserted into the hole on the finisher docking latch assembly (C). The finisher should be firmly
locked into position.
Finisher right carriage belt removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-380.
2. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-348.
3. Move the slip clutch gear 24T (A) toward the rear to disengage the stacker bin (B).
4. Move the stacker bin (B) to its lowest position.
Note: Make sure the stacker bin is at the lowest position before continuing.
To Next Page
Loading...
