Lexmark X95 series - Sensor (Booklet Unit Media Exit) Removal

4-388 Service Manual
7558-xxx
Go Back
Previous
Next
5. Remove sensor (booklet unit interlock) (A).
Sensor (booklet unit media exit) removal
1. Remove the booklet unit assembly. See “Booklet unit chassis removal” on page 4-335.
2. Remove the booklet unit assembly left cover. See “Booklet unit assembly left cover removal” on
page 4-334.
3. Remove the screw securing the Sensor (booklet unit media exit) bracket from the booklet unit assembly.
4. Disconnect the connector from the Sensor (booklet unit media exit) (A).
5. Remove the screw securing the Sensor (booklet unit media exit) (A) from the bracket.
Connector
A
Rear