Lexmark X95 series - Sensor (FB Scanner HP) Removal; Small Platen Glass Removal

Repair information 4-265
7558-xxx
Go Back
Previous
Next
Sensor (FB scanner HP) removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-19.
2. Remove the scanner rear cover. See “Scanner rear cover removal” on page 4-20.
3. Release the two harnesses from the clamp (A).
4. Remove the screw (B).
5. Remove the sensor (FB scanner HP) from the machine.
6. Disconnect the cable.
7. Remove sensor (FB scanner HP).
Small platen glass removal
1. Remove the operator panel assembly. See “Scanner controller PCBA removal” on page 4-238.
2. Remove the scanner rear cover. See “Scanner rear cover removal” on page 4-20.
3. Remove the scanner left cover. See “Scanner left cover removal” on page 4-19.