Lexmark X95 series - HCF Tray Lift Gear Bracket Removal

4-450 Service Manual
7558-xxx
Go Back
Previous
Next
3. Move the HCF transport shaft assembly (A) toward the rear in the direction of the arrow to remove it from
the bearing (B).
Note: The bearing (B) may become detached.
Note: When removing the HCF transport roller kit (A), do not touch the rubber surface.
Note: Before re-installing the HCF transport roller kit (A), do not touch the rubber surface.
HCF tray lift gear bracket removal
1. Remove the HCF media tray assembly. See “HCF media tray assembly removal” on page 4-436.
2. Remove the two e-clips with a prying tool securing the plastic retainer (A).
3. Remove the plastic retainer (A).
4. Remove the media tray lift shaft gear 51T (B).
5. Remove the media tray lift gear 25/40/14T (C).
6. Remove the three screws securing the HCF tray lift gear bracket (D) from the media tray.
A
E-clip
B