Lexmark X95 series - Tray Module Controller PCBA Removal; Tray Module Left Cover Removal

Repair information 4-279
7558-xxx
Go Back
Previous
Next
Tray module controller PCBA removal
This removal procedure applies to all three tray modules.
1. Remove the tray module rear cover. See “Tray module rear cover removal” on page 4-284.
2. Remove the six screws (A).
3. Disconnect all the cables from the tray module controller PCBA.
4. Remove the tray module controller PCBA.
Tray module left cover removal
1. Remove the tray module rear cover. See “Tray module rear cover removal” on page 4-284.
2. Remove the screw (A) securing the foot cover to the machine.