Lexmark X95 series - Sensor (Compiler Media Present) Late Jam

2-230 Service Manual
7558-xxx
Go Back
Previous
Next
487.05 Sensor (compiler media present) late jam
6
Check the exit stepper motor for
proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Exit motor.
Does the above component
operate properly?
Go to step 8. Go to step 7.
7
Check the stepper motor for
proper connection.
Is the above component
properly connected?
Replace the stepper motor.
Go to “Stepper motor (exit)
assembly and belt (exit)
removal” on page 4-417.
Replace the connection.
8
Check the finisher controller
PCBA for proper connection.
Is the above component
properly connected?
Go to Step 9. Replace the connections.
9
POR the machine.
Does the error continue?
Replace the finisher controller
PCBA.
Go to “Finisher PCBA removal”
on page 4-353.
Problem resolved
Step Action and questions Yes No
1 Check the media path.
Is the media path free of any
media fragments?
Go to step 2. Remove any media or media
fragments.
2
Check the eject shaft roll for
damage and contamination.
Is the above component free of
damage and contamination?
Go to Step 3. Replace the eject shaft roll. Go to
“Eject roll shaft removal” on
page 4-342.
Step Action and questions Yes No