Lexmark X95 series - Sensor (Stacker bin Level F) Removal

Repair information 4-401
7558-xxx
Go Back
Previous
Next
4. Release the hooks securing the sensor (punch waste box set) (A) to the finisher.
5. Remove the sensor (punch waste box set) (A).
Sensor (stacker bin level F) removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-348.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-380.
3. Disconnect the connector from the sensor (stacker bin level F) (A).
4. Remove the screw securing the sensor (stacker bin level F) (A) to the finisher.
5. Remove the sensor (stacker bin level F) (A).
A
Connector
Front
A
Connector