Lexmark X95 series - Upper Media Exit Roll Assembly Removal

4-424 Service Manual
7558-xxx
Go Back
Previous
Next
5. Remove the four screws securing the four upper media exit pinch roll assemblies (A) to the finisher.
6. Remove the four upper media exit pinch roll assembly (A).
Upper media exit roll assembly removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-380.
3. Remove the upper media bin assembly. See “Upper media bin assembly removal” on page 4-422.
4. Remove the top cover. See “Top cover removal” on page 4-421.
5. Remove the drive motor (exit). See “Stepper motor (exit) assembly and belt (exit) removal” on
page 4-417.
6. Disconnect the connector from the sensor (upper media exit) (A).
7. Release the harness from the clamps.
8. Remove the two front and two rear screws securing the upper exit guide assembly (B).
9. Remove the upper exit guide assembly.
Rear
A
Left
A
Left
Connector