Lexmark X95 series - Sub Paddle Removal; Switch (Eject Cover Interlock) Removal

Repair information 4-419
7558-xxx
Go Back
Previous
Next
Sub paddle removal
1. Remove the upper media bin assembly. See “Upper media bin assembly removal” on page 4-422.
2. Gently remove the two sub paddles (A) from the two shafts (B).
Reinstallation note: Make sure the sub paddles are properly installed as shown in the figure. The paddles
must not come in contact with the media eject unit assembly (C).
Switch (eject cover interlock) removal
1. Remove the upper media bin assembly. See “Upper media bin assembly removal” on page 4-422.
2. Disconnect the connector from the switch (eject cover interlock) (A).
3. Release the harness from the two clamps.
4. Remove the screw securing the bracket (B) to the finisher.
5. Remove the bracket (B) from the square hole in the finisher.
B
C
A