Lexmark X95 series - Finisher Sensor Tests

3-30 Service Manual
7558-xxx
Go Back
Previous
Next
FINISHER SENSOR TESTS
This test verifies that the sensors in the finisher are operating properly.
To run these tests:
1. From the Diagnostics Menu, navigate to SENSOR TESTS.
2. Select FINISHER SENSOR TESTS.
3. Select the test from the following options:
• Sensor (ADF inverter) • Sensor (ADF document tray length 2)
• Sensor (ADF top door interlock) • Sensor (FB scanner HP)
• Sensor (ADF closed interlock) • ADF connection detected
• Sensor (ADF document tray width 1) • Sensor (FB platen length 1)
• Sensor (ADF document tray width 2) • Sensor (FB platen length 2)
• Sensor (ADF document tray width 3) • Sensor FB angle)
Available finisher sensor tests:
• Sensor (booklet knife HP) • Sensor (rear tamper HP)
• Sensor (booklet compiler media
present)
• Sensor (stapler carriage HP)
• Sensor (booklet media exit) • Sensor (staple low)
• Sensor (booklet unit interlock) • Sensor (staple self priming)
• Sensor (booklet front staple low) • Sensor (staple motor HP)
• Sensor (booklet rear staple low) • Sensor (media eject clamp HP)
• Sensor (booklet bin media present) • Sensor (media eject shaft HP)
• Sensor (booklet front tamper HP) • Sensor (stacker bin upper limit)
• Sensor (booklet media entracne) • Sensor (stacker bin no media)
• Sensor (booklet rear tamper HP) • Sensor (stacker bin level encoder)
• Sensor (booklet end guide HP) • Sensor (stacker bin level 1)
• Sensor (booklet knife folding) • Sensor (stacker bin level 2)
• Sensor (finisher media entrance) • Sensor (punch carriage shift HP)
• Sensor (buffer path) • Sensor (punch cam HP)
• Sensor (diverter gate) • Sensor (punch cam front)
• Sensor (upper media exit) • Sensor (punch cam hole select)
• Sensor (lower media exit) • Sensor (punch unit motor encoder)
• Sensor (compiler media present) • Sensor (punch waste box set)
• Sensor (bridge media entrance) • Sensor (bridge bin exit)
• Sensor (bridge media exit) • Sensor (deculer cam HP)
• Sensor (punch side reg 1) • Sensor (eject cover interlock)
• Sensor (punch side reg 2) • Sensor (finisher front door interlock)
• Sensor (upper media bin full) • Sensor (bridge top door interlock)
• Sensor (front tamper HP)