Lexmark X95 series - Sensor (ADF Angle) Removal

Repair information 4-241
7558-xxx
Go Back
Previous
Next
12. Remove the seven screws (E) securing the scanner controller PCBA to the machine.
13. Remove the scanner controller PCBA from the machine.
Sensor (ADF angle) removal
1. Remove the scanner rear cover. See “Scanner rear cover removal” on page 4-20.
2. Remove the scanner left cover. See “Scanner left cover removal” on page 4-19.
3. Remove the ADF angle actuator. See “ADF angle actuator removal” on page 4-202.
Note: The hooks for the sensor can be accessed more easily by removing the large platen glass.
4. Release the hooks (A) securing the sensor (ADF angle) to the machine.
5. Remove the sensor (ADF angle).