Repair information 4-61
7558-xxx
c. Pull the gate (D), and move it to its lowest position.
• Move the appropriate wiper in and out to clean the printhead.
Developer housing (M) removal
1. Remove the printer front door. See “Printer front door removal” on page 4-13.
2. Remove the transfer belt cleaner. See “Transfer belt cleaner removal” on page 4-178.
3. Remove the waste toner box.
4. Remove the four photoconductor units.
5. Remove the four toner supplies.
6. Remove the operator panel left cover. See “Operator panel left cover removal” on page 4-10.
7. Remove the operator panel right cover. See “Operator panel right cover removal” on page 4-11.
To Next Page
Loading...
