Lexmark X95 series - Page 540

4-62 Service Manual
7558-xxx
Go Back
Previous
Next
8. Remove the operator panel front cover. See “Operator panel front cover (MFP) removal” on page 4-8.
9. Remove the printhead retract door. See “Printhead retract door removal” on page 4-145.
10. Remove the inner cover. See “Inner cover removal” on page 4-4.
11. Remove the inner plate. See “Inner plate removal” on page 4-98.
12. Remove the ATC sensor PCB bracket. See “ATC sensor PCB bracket removal” on page 4-29.
13. Remove the waste toner auger chute. See “Waste toner auger chute removal” on page 4-194.
14. Lift the appropriate plastic gate, and push it in to reduce toner spillage.
15. Detach the lower portion (A) of the auger from the appropriate developer housing.
1
2
A