Lexmark X95 series - Sensor (Booklet Knife HP) Removal

Repair information 4-385
7558-xxx
Go Back
Previous
Next
5. Remove sensor (booklet knife folding) (A).
Sensor (booklet knife HP) removal
1. Remove the booklet unit assembly. See “Booklet unit chassis removal” on page 4-335.
2. Remove the booklet unit assembly left cover. See “Booklet unit assembly left cover removal” on
page 4-334.
3. Rotate knife sector gear clockwise until the flag is in the folding sensor position.
4. Remove one screw securing the sensor (knife HP sensor & Knife folding sensor) from the knife frame
assembly.
5. Disconnect the connector from the sensor (booklet knife HP and booklet knife folding).
Connector
A
Left