Lexmark X95 series - Finisher Removal Procedures; Booklet bin Assembly Removal; Booklet bin Hookup Cable Assembly Removal

Repair information 4-321
7558-xxx
Go Back
Previous
Next
Finisher removal procedures
Booklet bin assembly removal
1. Disconnect booklet hookup cable assembly from the booklet bin assembly.
2. Remove the screw securing the booklet bin assembly (A) to the finisher.
3. Remove booklet bin assembly (A).
Booklet bin hookup cable assembly removal
1. Disconnect booklet hookup cable assembly from the booklet bin assembly.
2. Remove rear lower cover. See “Upper media bin front cover removal” on page 4-423.
3. Disconnect the booklet bin hookup cable assembly from the rear of the finisher.
4. Release the clamps securing the booklet bin hookup cable assembly from the finisher.